Toro Workman HD 07369, Operator'S Manual

Page: 36 / 56

Figure 31
1. Wear block 3. Carriage bolt
2. Spacer bracket
1. Ensure that the lift cylinders are fully retracted.
2. Carefully set the bed onto the machine frame, aligning
the rear bed pivot-plate holes with the holes in the rear
frame channel and install 2 clevis pins and lynch pins
(
Figure 31 ).
3. With the bed lowered, secure each cylinder rod end, to
the appropriate slots in the bed-mounting plates with a
clevis pin and lynch pin.
4. Insert the clevis pin from outside of the bed with the
lynch pin toward the outside (
Figure 31 ).
Note:
The rear slots are for a full bed installation and
front slots are for a 2/3 bed installation.
Note:
The engine may need to be started to extend or
retract the cylinders for alignment with the holes.
Note:
The unused slot can be plugged with a bolt and
nut to prevent assembly errors.
5. Start the engine and engage the hydraulic-lift lever to
raise the bed.
6. Release the lift lever and turn off the engine.
7. Install the bed-safety support to prevent accidental
lowering of the bed; refer to
Using the Bed Support
(page 34) .
8. Install the lynch pins to the inside ends of the clevis
pins.
Note:
If the automatic-tailgate release has been
installed on the bed, ensure that the front dump link
rod has been placed on the inside of the left side clevis
pin before you install the lynch pin.
Raising the Machine
DANGER
A machine on a jack may be unstable and slip off of
the jack, injuring anyone beneath it.
• Do not start the machine while the machine is
on a jack.
• Always remove the key from the switch before
getting off the machine.
• Block the tires when the machine is on a jack.
•
Do not start the engine while the machine is on a jack,
because the engine vibration or wheel movement could
cause the machine to slip off the jack.
•
Do not work under the machine without jack stands
supporting it. The machine could slip off a jack, injuring
anyone beneath it.
•
When jacking up the front of the vehicle, always place a
wooden block (or similar material) between the jack and
the machine frame.
•
The jacking point at the front of the machine is under the
front center frame support (
Figure 32 ) and at the rear it is
under the axle ( Figure 33 ).
Figure 32
1. Front jacking points
36