Toro Workman GTX, Service Manual

Page: 157 / 187

Workman GTX Gasoline Page 6 -- 45 Chassis
Removal (Fig. 44)
1. Park vehicle on a level surface, stop engine, apply
parking brake and remove key from the key switch.
2. Raise hood to allow access to wire harness connec-
tions to switches mounted in dash.
3. Disconnect wire harness connectors from all switch-
es and power ports on dash.
4. Remove ten (10) washer head screws that secure
dash to vehicle.
NOTE: It is not necessary to remove choke cable from
dash unless dash needs to be completely removed from
vehicle.
5. Carefully lift dash from vehicle supports until it clears
the parking brake lever and position it toward the front
of the vehicle.
6. If dash needs to be replaced or completely removed
from vehicle, disconnect choke cable from engine and
remove it from dash.
Installation (Fig. 44)
NOTE: Do not fully tighten fasteners securing dash un-
til all fasteners are in place.
1. If choke cable was removed, install choke cable to
dash and engine.
2. Carefully position dash to vehicle by lowering it over
parking brake lever.
3. Secure dash with removed washer head screws us-
ing fastener torque specifications that are identified in
Figure 44.
4. Make sure that choke operation is correct.
IMPORTANT: Make sure that the USB power point is
connected with the correct polarity. The white (posi-
tive) harness wire should be connected to the upper
USB power point terminal.
5. Connect wire harness connectors to all switches and
power ports on dash.
6. Lower and secure front hood.
Ch
as
si
s