Toro WORKMAN GTX 07131, Operator'S Manual

Page: 38 / 48

Replacing the Headlight
1. Disconnect the batteries; refer to Disconnecting the
Batteries (page 35) .
2. Open the hood; refer to Accessing the Hood (page 29) .
3. Disconnect the electrical connector for the harness
from the connector of the lamp assembly (
Figure 42 ).
Figure 42
1. Speed clip
4. Headlight
2. Opening in the bumper 5. Lamp assembly
3. Adjustment screw 6. Harness-electrical
connector
4. Remove the speed clips that secure the headlight to the
headlight bracket (
Figure 42 ).
Note:
Retain all parts for installation of the new
headlight.
5. Remove the headlight assembly by moving it forward
through the opening in the front bumper (
Figure 42 ).
6. Install the new headlight through the opening in the
bumper (
Figure 42 ).
Note:
Ensure the adjustment posts are lined up with
the holes in the mounting bracket behind the bumper.
7. Secure the headlight assembly with the speed clips that
you removed in step
4 .
8. Connect the electrical connector for the harness to the
connector of the lamp assembly (
Figure 42 ).
9. Adjust the headlights to direct the beams to the desired
position, refer to
Adjusting the Headlights (page 38) .
Adjusting the Headlights
Use the following procedure to adjust the headlight beam
position whenever a headlight assembly is replaced or
removed.
1. Turn the key switch to the O
N
position, and turn on
the headlights.
2. At the back of the headlight assembly, rotate adjustment
screws (
Figure 42 ) to pivot the headlight assembly and
align the position of the cast beam.
3. Connect the battery and close the hood; refer to
Connecting the Batteries (page 36) .
38