11
3. Pull the height-of-cut lever out to disengage it from the
quadrant (Fig. 22).
m–3474
1
2
3
4
5
Figure 22
1.
Height-of-cut lever
2.
Quadrant
3.
High
4.
Low
5.
Medium position
4. Adjust the height-of-cut to the desired level (Fig. 22).
5. Release the lever inward to lock it into the quadrant
(Fig. 22).
Removing the Mower
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Lower the mower.
4. Remove the washer (3/4 inch) and a hairpin cotter from
the attachment lift pin into the slot in the center lever
bar (Fig. 4).
5. Open the mid-mount hitch by pulling out the J–pin and
moving the lock handle rearward (Fig. 23).
6. Turn the right knob on the front pulley box to loosen the
mower drive belt (Fig. 8).
7. Remove the mower drive belt from the mower (Fig. 9).
8. Remove the mower drive belt from the lower pulley and
lower idler pulley in the pulley box (Fig. 9).
9. Turn the front wheels fully to the left and raise the
attachment lift lever or electric lift all the way up.
m–6622
1
4
2
3
Figure 23
1.
Front hitch
2.
Mid-mount hitch
3.
J–pin
4.
Lock handle
10. Slide the mower from under the chassis to the right side
of the tractor (Fig. 4).
11. If needed, remove the pulley box by pushing on the
release lever and removing the pulley box (Fig. 23).
