10
1
5
4
6
3
1281
4
3
2
2
5
Figure 3
1.
Top plate
2.
Long shoulder bolt,
3/8 x 1 in.
3.
Washer, 3/8 in.
4.
Locknut, 3/8 in.
5.
Side plate
6.
Cutting edge
2. Position the side plates outside the housing side flanges,
with the cutting edges parallel to side of the housing,
securing them with 6 long shoulder bolts (3/8 x 1 in.)
(heads on the inside), 6 washers (3/8 in.), and 6 locknuts
(3/8 in.) (Fig. 3).
Installing the Discharge Chute
and Rotar Assembly
1. Install the lower discharge chute and deflector shield
onto the housing with
3 carriage bolts (5/16 x 3/4 in.)
(heads to the inside), 3 washers (5/16 in.), and 3
locknuts (5/16 in.) (Fig. 4).
2
3
4
2241
5
1
Figure 4
1.
Discharge chute
2.
Deflector shield
3.
Carriage bolt, 5/16 x
3/4 in.
4.
Washer, 5/16 in.
5.
Locknut, 5/16 in.
2. Assemble the upper discharge chute section outside and
on top of the lower section with 3 bolts (5/16 x 5/8 in.)
(heads on the inside), 3 washers (5/16 in.), and 3
locknuts (5/16 in.) (Fig. 5).
1290
1
3
2
5
4
Figure 5
1.
Upper section
2.
Lower section
3.
Bolt, 5/16 x 5/8 in.
4.
Washer, 5/16 in.
5.
Locknut, 5/16 in.
3. Install the discharge chute rotator assembly into the slot
in the housing with a carriage bolt (5/16 x 1 in.) (head
to the top), pyramidal washer (5/16 in.), and locknut
(5/16 in.) (Fig. 6).
1
2
3
1280
4
5
Figure 6
1.
Rotator assembly
2.
Carriage bolt, 5/16 x 1 in.
3.
Pyramidal washer,
5/16 in.
4.
Locknut, 5/16 in.
5.
Worm gear
4. Adjust the rotator assembly so that the worm gear is at
right angle with the chute, the teeth mesh fully, and the
chute turns freely. Tighten the locknut securely.
