Maintenance
43
Front-to-Rear Blade Slope
Check the front-to-rear blade slope any time you
install the mower. Before you check the slope, set the
air pressure in the front and rear tires to the
recommended inflation. Refer “Tire Pressure”
(page 21) in the Maintenance Section. If the front of
the mower is not within a range of 1/8”–3/8”
(3.5 mm–10.5 mm) lower than the rear of the mower,
adjust the blade slope using the following
instructions:
1.
Park the machine on a level surface, disengage
the blade control (PTO), shift into neutral, set
the parking brake, and turn the ignition key to
“OFF” to stop the engine.
2.
Remove the key from the ignition switch and
pull the wire off the spark plug.
3.
Check and adjust side-to-side blade level if you
have not checked the setting; refer to
Side-to-Side Mower Leveling, page 42.
4.
Move the height-of-cut lever (deck lift) into the
“C” notch.
5.
Measure the length of the rod extending out the
front of the adjusting block on the sides of the
chassis (Fig. 50). If the rod length is not 5/8”
(16 mm), remove the hair pin cotter and washer
from the end of the rod (Fig. 50), and turn the
rod until the 5/8” (16 mm) dimension is
obtained. Then install the end of the rod into the
hole in the mower mount and secure in place
with washer and hair pin cotter. Repeat this
procedure on the opposite side of the mower.
5/8”
(16 mm)
1
2
3
4
1805
Figure 50
1.
Adjusting block
2.
Long rod
3.
Hairpin cotter and washer
4.
Mower mount
6.
Check the front to rear slope by measuring
between the bottom of the mower
(front center and rear center) and the flat surface
(Fig. 51). If the front is not within a range of
1/8”–3/8” (3.5mm–10.5mm) lower than the rear,
an adjustment is required.
Summary of Contents for Wheel Horse 16-38 XLE
Page 7: ...Safety 5 Slope Chart Read all safety instructions on pages 2 8...
Page 8: ...6...
Page 27: ...Maintenance 25 Wiring Diagram...
Page 52: ......
