Toro TransPro 80, Installation Instructions Manual

Page: 6 / 16

Loading the Trailer
1. While maintaining control of the trailer bed and
holding onto the handle, press down on the latch
assembly and the lift handle (
Figure 11 ). Lower
the trailer bed to the ground.
g014670
Figure 11
1. Latch assembly 2. Handle
2. On flat ramps, pivot the wheel rods upward
(
Figure 13 ) and on rail ramps, rotate the wheel
rods parallel (open) to the ramp ( Figure 14 ).
3. Remove the basket from the greens mower,
disengage the reel drive, and move the throttle
to the slowest position.
Slowly drive the greens
mower onto the trailer until you contact the
wheel stops (
Figure 12 ).
4. If the rail wheels are not centered on the rails,
loosen the fasteners securing the rails to the
trailer and adjust the rail position so that the rail
wheels are centered, then tighten the fasteners.
5. Shut off the engine and engage the parking
brake.
6. Engage the wheel rods as follows:
•
On flat ramps, rotate the wheel rods
downward over the greensmower transport
wheels (
Figure 13 ).
•
On rail ramps, lift the wheel rod and rotate it
behind the greensmower transport wheels
(
Figure 14 ).
g214902
Figure 12
Greensmower loaded on a TransPro 80 with Rail Kit
g014671
Figure 13
1. Wheel rod (shown in pivoted down position)
6