Figure 58
1.
Blades side to side
3.
Measure from the tip of the
blade to the flat surface
here
2.
Outside cutting edges
Checking the Front-to-Rear Blade Slope
Check the front-to-rear blade level any time you install the
mower. If the front of the mower is more than 7.9 mm
(5/16 inch) lower than the rear of the mower, adjust the blade
level using the following instructions:
1.
Park the machine on a level surface and disengage the
blade control switch.
2.
Move the motion control levers outward to the neutral
position, engage the parking brake, stop the engine,
remove the key, and wait for all moving parts to stop
before leaving the operating position.
3.
Carefully rotate the blades so they are facing front to
rear (Figure 59).
4.
Measure from the tip of the front blade to the flat
surface and the tip of the rear blade to the flat surface
(Figure 59).
Note:
If the front blade tip is not 1.6-7.9 mm
(1/16-5/16 inch) lower than the rear blade tip, continue
to the Leveling the Mower Deck procedure.
Figure 59
1.
Blades front to rear
3.
Measure from the tip of the
blade to the flat surface
here
2.
Outside cutting edges
Leveling the Mower Deck
1.
Set anti-scalp rollers to top holes or remove completely
for this procedure; refer to Adjusting the Anti-Scalp
Rollers (page 22).
2.
Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to Adjusting the Height-of-Cut (page
21).
3.
Place two 6.66 cm (2-5/8 inch) blocks under each
side of the front edge of the deck, but not under the
anti-scalp roller brackets (Figure 60).
4.
Place two 7.30 cm (2-7/8 inch) thick blocks under the
rear edge of the cutting deck skirt; one on each side of
the cutting deck (Figure 60).
Figure 60
1.
Wood block, 6.66 cm
(2-5/8 inch) thick
3.
Front edge
2.
Wood block, 7.30 cm
(2-7/8 inch) thick
5.
Loosen the adjustment bolts on all four corners so that
the deck is sitting securely on all four blocks (Figure
61).
41
Summary of Contents for Titan MX5400
Page 50: ...Schematics Wire Diagram Rev A 50 ...
Page 51: ...Notes 51 ...
