Toro titan mx, Service Manual

Page: 42 / 108

CHASSIS
3-22 Toro TITAN 2014 Service Manual
3
10. Inspect the front lift pan, front pivot rod (F), the rear
pivot rod (H) and all pivot points for excessive wear,
bends and cracks. Replace if necessary.
Deck Lift Installation
1. Install the front and rear pivot rods (F and H) into the
frame slots and support in position.
2. Install the (4) pivot bushings (G), (4) gusset plates
and (8) fasteners that secure the pivot rods to the
frame. Torque the (8) fasteners to specification – 5
ft-lbs. (7 Nm) (Fig. 040).
Fig. 040
PICT-2087
Deck Lift Service
Deck Lift Removal
Note: Exploded view shown on next page, 3-23.
1. Remove the PTO belt tensioner spring, then remove
the PTO belt from the PTO clutch. See “PTO Belt
Replacement - 48, 54 & 60 Inch Deck” on page 6-5.
2. Remove the deck from the frame. See “Mower Deck
Removal - 48, 54 & 60 Inch Deck” on page 6-7.
3. Remove the deck lift foot pedal center pivot bolt (A).
4. Remove the rear lift arm pivot bolt (B).
5. Remove the (2) HOC plate assembly mounting
bolts (C).
6. Remove the HOC plate and foot lift assembly from
the chassis (Fig. 039).
G
Fig. 039
PICT-3029
A
B
C
7. Remove the front lift pan spring (D), and (2) pivot
bolts (E).
8. Support under the front foot lift pivot rod (F).Remove
the (4) fasteners that retain the pivot bushings (G).
Remove the pivot rod from the frame. Inspect the (2)
bushings for wear and replace if necessary.
9. Support under the rear pivot rod (H). Remove the
(4) fasteners that retain the pivot bushings (G).
Remove the pivot rod from the frame. Inspect the (2)
bushings for wear and replace if necessary.