Toro TimeCutter ZS 4200S, Operator'S Manual

Page: 48 / 228

Removing the Mower Deck
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
ARK
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Loosen the bottom 2 bolts holding the
mower-deck curtain to the mower deck. Refer to
Releasing the Mower-Deck Curtain (page 29) .
5. Remove the hairpin cotter from the front support
rod, and remove the rod from the deck bracket
(
Figure 69 ).
g014635
Figure 69
1. Front support rod 3. Deck bracket
2. Locking nut
6. Carefully lower the front of the mower deck to
the ground.
7. On 1 side of the machine, remove the washer
and hairpin cotter from the deck pin (
Figure 70 ).
g295768
Figure 70
1. Lift arm
3. Washer
2. Hairpin cotter
8. Remove the lift arm from the deck pin ( Figure
70 ).
9. Repeat steps 7 and 8 for the other side of the
machine.
10. Slide the mower deck rearward to remove the
mower belt from the engine pulley.
11. Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.
Installing the Mower Deck
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
ARK
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest
position.
5. On 1 side of the machine, lift the rear of the
mower deck and install the lift arm to the deck
pin (
Figure 70 ).
6. Install the lift arm using the washer and hairpin
cotter (
Figure 70 ).
7. Repeat steps 5 and 6 for the other side of the
machine.
46