G015325
1
2
Figure 63
1.
0.25 inch
2.
0.125 inch
11.
Stop the deck at the adjusted position and tighten the
side locking nut on the hanger bracket to hold the new
position (Figure 62). Tighten the rear locking nut on
the hanger bracket.
12.
Continue leveling the deck by checking the front-to-rear
blade slope; refer to Adjusting the Front-to-Rear Blade
Slope.
Adjusting the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install the
mower. If the front of the mower is more than 5/16 inch
(7.9 mm) lower than the rear of the mower, adjust the blade
level using the following instructions:
1.
Park the machine on a level surface and disengage the
blade control switch.
2.
Move the motion control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3.
Set the height-of-cut lever to middle position.
Note:
Check and adjust the side-to-side blade level if
you have not checked the setting; refer to Side-to-Side
Leveling.
4.
Carefully rotate the blades so they are facing front to
rear (Figure 64 and Figure 65).
G009658
1
2
2
Figure 64
Mower Decks with 2 Blades
1.
Blades front to rear
2.
Measure from the tip of the blade to the flat surface here
G009659
1
2
3
2
3
Figure 65
Mower Decks with 3 Blades
1.
Blades front to rear
3.
Measure from the tip of the
blade to the flat surface
here
2.
Outside cutting edges
5.
Measure from the tip of the front blade to the flat
surface and the tip of the rear blade to the flat surface
(Figure 64 and Figure 65). If the front blade tip is not
1/16-5/16 inch (1.6-7.9 mm) lower than the rear blade
tip, adjust the front locknut.
6.
To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower (Figure 66).
44
Summary of Contents for TimeCutter ZS 4200
Page 52: ...Schematics G014644 Electrical Diagram Rev A 52 ...
Page 53: ...Notes 53 ...
Page 54: ...Notes 54 ...
