G014634
1
2
3
Figure 62
1.
Adjusting rod
3.
Locknut
2.
Adjusting block
7.
To raise the front of the mower, tighten the adjustment
nut.
8.
To lower the front of the mower, loosen the adjustment
nut.
9.
After adjustment, check the front-to-rear slope again,
continue adjusting the nut until the front blade tip is
1.6 to 7.9 mm (1/16 to 5/16 inch) lower than the rear
blade tip (
).
10.
When the front-to-rear blade slope is correct check the
side-to-side level of the mower again; refer to
from Side to Side (page 41)
.
Removing the Mower
1.
Park the machine on a level surface and disengage the
blade-control switch.
2.
Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3.
Lower the height-of-cut lever to the lowest position.
4.
Loosen the bottom 2 bolts holding the mower-deck
curtain to the mower deck. Refer to
Mower-Deck Curtain (page 28)
.
5.
Remove the hairpin cotter from the front support rod,
and remove the rod from the deck bracket (
). Carefully lower the front of the mower deck to
the ground.
G014635
1
2
3
Figure 63
1.
Front support rod
3.
Deck bracket
2.
Locking nut
6.
Lift the mower deck and hanger brackets clear of the
rear lift rod, and lower the mower carefully to the
ground (
).
G015338
2
2
3
1
2
2
3
Figure 64
Mower decks with 1 blade
1.
Mower deck
3.
Rear lift rod
2.
Hanger bracket
43
Summary of Contents for TimeCutter ZS 3200S
Page 51: ...Schematics Electrical Diagram Rev A 51 ...
Page 52: ...Notes 52 ...
Page 53: ...Notes 53 ...
Page 54: ...Notes 54 ...
