Figure 59
1.
Hanger bracket
3.
Rear locking nut
2.
Side locking nut
9.
Check the side-to-side adjustments again.
Note:
Repeat this procedure until the measurements
are correct.
10.
Continue leveling the deck by checking the front-to-rear
blade slope; refer to
Adjusting the Front-to-Rear Blade
.
Adjusting the Front-to-Rear Blade
Slope
Check the front-to-rear blade slope any time you install the
mower. If the front of the mower is more than 7.9 mm
(5/16 inch) lower than the rear of the mower, adjust the blade
level using the following instructions:
1.
Park the machine on a level surface and disengage the
blade-control switch.
2.
Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3.
Set the height-of-cut lever to middle position.
Note:
Check and adjust the side-to-side blade level
if you have not checked the setting; refer to
from Side to Side (page 41)
.
4.
Carefully rotate the blades so they are facing front to
rear (
and
G014631
1
2
2
Figure 60
Mower decks with 1 blade
1.
Blade front to rear
2.
Measure from the tip of the blade to the flat surface here.
G009658
1
2
2
Figure 61
Mower decks with 2 blades
1.
Blades front to rear
2.
Measure from the tip of the blade to the flat surface here
5.
Measure from the tip of the front blade to the flat
surface and the tip of the rear blade to the flat surface
(
).
Note:
If the front blade tip is not 1.6 to 7.9 mm (1/16
to 5/16 inch) lower than the rear blade tip, adjust the
front locknut.
6.
To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower (
).
42
Summary of Contents for TimeCutter ZS 3200S
Page 51: ...Schematics Electrical Diagram Rev A 51 ...
Page 52: ...Notes 52 ...
Page 53: ...Notes 53 ...
Page 54: ...Notes 54 ...
