Toro TimeCutter Z380, Operator'S Manual

Page: 36 / 44

Figure 50
1. Mower belt 5. Engine pulley
2. Idler arm 6. Belt cover
3. Outside pulley 7. Belt guide
4. Spring 8. Idler pulley
5. Pull the idler pulley in the direction shown in
Figure 50 and roll the belt off of the pulleys.
The spring is under tension when
installed and can cause personal injury.
Be careful when removing the spring.
6. Route the new belt around the engine pulley
and mower pulleys (Figure 50).
7. Pull the idler pulley in the direction shown
in Figure 50 and route the belt onto the idler
pulley (Figure 50).
8. Rotate the belt guide, on the idler arm, towards
the pulley until it stops (Figure 50).
9. Tighten the belt guide (Figure 50).
10. Install the belt covers over the outside spindles.
Installing the Mower
1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers outward to the
park position, stop the engine, remove the key,
and wait for all moving parts to stop before
leaving the operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest
position.
5. Attach the adjusting rod to the machine with
the washer and hairpin cotter (Figure 49) on
each side of the mower.
6. Slide the leveling brackets onto the mounting
pins and secure them with the washers and
hairpin cotters (Figure 49).
7. Attach the front support rods to the machine
with the clevis pins and hairpin cotters
(Figure 48).
8. Install the mower belt onto the engine pulley;
refer to Replacing the Mower Belt.
Replacing the Grass
Deector
An uncovered discharge opening could
allow the lawn mower to throw objects in
the operator’s or bystander’s direction and
result in serious injury. Also, contact with
the blade could occur.
Never operate the lawn mower unless you
install a cover plate, a mulch plate, or a grass
chute and catcher.
1. Locate items shown in Figure 51.
2. Remove the nut (3/8 inch) from the rod under
the mower (Figure 51).
3. Slide the rod out of the short stand-off,
internal lock washer, spring, and grass deflector
(Figure 51). Remove the damaged or worn
grass deflector.
4. Replace the grass deflector and internal lock
washer (Figure 51).
5. Slide rod, straight end, through the rear grass
deflector bracket.
6. Place the spring on the rod, with end wires
down, and between the grass deflector brackets.
36