WARNING
Open holes in the mower expose you and
others to thrown debris which can cause
severe injury.
•
Never operate the mower without hardware
mounted in all holes in the mower housing.
•
Install the hardware in the mounting holes
when you remove the mulching baffle.
7.
Install the right mower blade; refer to
Installing the
Blades (page 45)
.
8.
Lift up the grass deflector. Install 2 bolts (5/16 x 3/4
inch) to the two holes along the deck cutout.
9.
Install the cutoff baffle to the mower deck (
Figure 25
).
Note:
Use the 2 locknuts (5/16 inch) to secure the
baffle to the mower deck.
Note:
The cutoff baffle was shipped with the machine
as a loose part.
G015321
1
2
3
Figure 25
1.
Bolt (5/16 x 3/4 inch)
3.
Locknut (5/16 inch)
2.
Cutoff baffle
10.
Torque the fasteners to 7 to 9 N-m (14 to 18 ft-lb).
11.
Lower the grass deflector over the discharge opening.
Important:
Ensure that the mower has a hinged
grass deflector that disperses clippings to the side
and down toward the turf, while in side discharge
mode.
Installing the Right Baffle for Mulching
1.
Park the machine on a level surface and disengage the
blade-control switch.
2.
Ensure the parking brake is engaged, stop the engine,
remove the key, and wait for all moving parts to stop
before leaving the operating position.
3.
Remove the cutoff baffle from the mower deck (
Figure
25
).
4.
Remove the right mower blade; refer to
Removing the
Blades (page 44)
.
5.
Slide the right baffle under the mower deck, and secure
it using 2 knobs and the curved washers (cupped side
facing the mower) as shown in
Figure 23
and
Figure 24
.
Important:
Ensure that the tab on the far right
side of the right baffle is outside of the mower and
is flush with the mower wall.
6.
Install the right mower blade; refer to
Installing the
Blades (page 45)
.
28
Summary of Contents for TimeCutter SW 4200
Page 55: ...Schematics Electrical Diagram Rev A 55 ...
Page 56: ...Notes 56 ...
Page 57: ...Notes 57 ...
Page 58: ...Notes 58 ...
