8
Installing the TBC
TM
WP Controller Module
Install the TBC
TM
WP controller next to the valve(s), inside a valve box.
Step 1 –
Position the TBC
TM
WP controller
inside the valve box. Select a
position such that the battery
compartment and the IR port can
be easily accessed. Mark the
screw hole position on the valve
box.
Step 2 –
Secure the two mounting screws
on the marked location. Leave
approximately 1/4" (6mm) of the
exposed screw.
Step 3 –
Hang the controller onto the
screws. Verify that the screws are
seated properly at the top of the
keyhole slot.
Step 4 –
Tighten the screws to secure the
controller.
IMPORTANT:
For controller
with integrated radio interface,
position the antenna upright for
optimum performance.
Step 5 –
Write the hand-held and controller module numbers on the provided label.
See TBC
TM
HH manual for details.
TBCWP
