Toro Super Recycler 21681, Operator'S Manual

Page: 5 / 92

Setup
Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
1
Unfolding the Handle
No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
1. Loosen the handle knobs ( Figure 4 ).
g020721
Figure 4
1. Handle knobs
2. Carefully move the upper handle forward until
the handle halves are in line and nest together
as shown in
Figure 5 .
g020722
Figure 5
3. Tighten the handle knobs firmly by hand.
4. Rotate the handle rearward to the operating
position, and lock the handle at your desired
height. Refer to
Adjusting the Handle Height
(page 8) .
4