Toro Super Recycler 21565, Operator'S Manual

Page: 15 / 28

Starting the Engine
1. Hold the blade-control bar against the handle
(A of
Figure 13 ).
2. Pull the recoil-start handle (B of Figure 13 ).
Note:
When you pull the recoil-start handle,
pull it lightly until you feel resistance, then pull it
sharply. Allow the rope to return to the handle
slowly.
Note:
If the machine does not start after several
attempts, contact an Authorized Service Dealer.
g367809
Figure 13
Using the Self-Propel Drive
To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the machine will automatically keep pace
with you (
Figure 14 ).
g334136
Figure 14
Note:
If the machine does not freely roll backward
after self-propelling, stop walking, hold your hands
in place, and allow the machine to roll a couple of
centimeters (inches) forward to disengage the wheel
drive. You can also try reaching just under the upper
handle to the metal handle and pushing the machine
forward a couple of centimeters (inches). If the
machine still does not roll backward easily, contact an
Authorized Service Dealer.
Shutting Off the Engine
Service Interval: Before each use or daily—Ensure
that the engine shuts off within
3 seconds after releasing the
blade-control bar.
To shut off the engine, release the blade-control bar.
Important:
When you release the blade-control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop
using your machine immediately and contact an
Authorized Service Dealer.
15