Toro Super Recycler 20382, Operator'S Manual

Page: 12 / 72

g003274
Figure 16
Note:
If the machine does not start, contact an
Authorized Service Dealer.
Using the Self-Propel Drive
To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the machine will automatically keep pace
with you (
Figure 17 ).
g003221
Figure 17
Stopping the Engine
Release the blade-control bar ( Figure 18 ).
Important:
When you release the blade-control
bar, the blade should stop within 3 seconds. If it
does not stop properly, stop using your machine
immediately and contact an Authorized Service
Dealer.
g003126
Figure 18
Recycling the Clippings
Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine, remove it; refer to
Removing the Grass Bag (page 13) before recycling
the clippings. If the side-discharge chute is on the
machine, remove it and lock the side-discharge door;
refer to
Removing the Side-Discharge Chute (page
15) before recycling the clippings.
Important:
Ensure that the rear-discharge plug
is locked in place. To lock the plug: Raise the
discharge deflector (
Figure 19 ), firmly push the
plug in until it snaps into place behind the tabs,
and rotate the lever on the plug to the left (
Figure
20 ).
g017463
Figure 19
1. Discharge deflector 2. Rear-discharge plug
11