g038696
Figure 20
1.
R
ECYCLING
position
2.
B
AGGING
position
Bagging the Clippings
Use the grass bag to collect grass and leaf clippings
from the lawn.
WARNING
A worn grass bag could allow small stones
and other similar debris to be thrown toward
you or bystanders, resulting in serious
personal injury or death.
Check the grass bag frequently. If it is
damaged, install a new Toro replacement bag.
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury.
Shut off the engine and wait for all moving
parts to stop before leaving the operating
position.
1.
Shut off the engine and wait for all moving parts
to stop.
2.
Install the grass bag; refer to
and move the bag-on-demand
lever to the
BAGGING
position as shown in
Installing the Grass Bag
1.
Shut off the engine and wait for all moving parts
to stop.
2.
Raise and hold up the rear deflector, install the
bag in the notches, and lower the rear deflector
(
).
g038773
Figure 21
Removing the Grass Bag
1.
Shut off the engine and wait for all moving parts
to stop.
2.
Lift up the grass bag up and away from the
handle.
Note:
Tilt the grass bag slightly backward to
prevent the collected grass clippings from falling
out.
Rear-Discharging the
Clippings
Use the rear discharge for cutting very tall grass.
Note:
If the grass bag is on the machine, remove
it before rear-discharging the clippings; refer
to
Removing the Grass Bag (page 13)
. The
13
