Toro Super Bagger 20192, Operator'S Manual, Page: 10 / 24

Figure 20
3. Move the choke lever to the Choke position
(Figure 21).
Figure 21
4. Hold the blade control bar against the handle and
pull the recoil starter (Figure 22).
Figure 22
1. Blade control bar
Note:
The choke lever will automatically move to
the Off position while you hold the blade control bar.
5. If the mower does not start in 1 or 2 pulls, repeat
steps 3 and 4.
Note:
If the mower still does not start, contact an
Authorized Service Dealer.
Using the Self-propel Drive
To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the mower will automatically keep pace with
you (Figure 23).
Figure 23
1. Nudge here
Note:
If, when backing up after self-propelling, the
mower does not roll backward freely, nudge the mower
forward about an inch or two without engaging the
self-propel drive (Figure 23), then pull the mower
backward.
Stopping the Engine
Service Interval: Before each use or daily
To stop the engine, release the blade control bar
(Figure 24).
Important:
When you release the blade control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop using
your mower immediately and contact an Authorized
Service Dealer.
Figure 24
Mulching the Clippings
Your mower comes from the factory ready to mulch the
grass and leaf clippings back into the lawn.
If the grass bag is on the mower, remove it (refer to
Removing the Grass Bag) before mulching the clippings.
If the side discharge chute is on the mower, remove it
and lock the side discharge door (refer to Removing the
Side Discharge Chute) before mulching the clippings.
10