Toro STX-26, Operator'S Manual

Page: 28 / 48

Replacing the Fuel Filter
Service Interval: Every 200 hours
1. Park the machine on a level surface, engage the
parking brake, and lower the hydraulic lift.
2. Shut off the engine and remove the key.
g242257
g033082
Figure 36
Electrical System
Maintenance
Servicing the Battery
Service Interval: Every 25 hours—Check the battery
electrolyte level.
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution of
4 parts water and 1 part baking soda. Apply a light
coating of grease to the battery terminals to reduce
corrosion.
Voltage: 12 V with 300 A (cold cranking) at -18°C
(0°F).
WARNING
Incorrect battery cable routing could damage
the machine and cables, causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
cable before disconnecting the positive
(red) cable.
• Always connect the positive (red) cable
before connecting the negative (black)
cable.
WARNING
Battery terminals or metal tools could short
against metal components, causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the traction unit.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
traction unit.
Removing the Battery
1. Park the machine on a level surface, engage the
parking brake, and lower the hydraulic lift.
2. Shut off the engine and remove the key.
3. Lift the black rubber cover on the negative cable.
Disconnect the negative battery cable from the
negative (-) battery terminal (
Figure 37 ).
28