Figure 37
1.
Positive battery post
3.
Red (+) charger lead
2.
Negative battery post
4.
Black (-) charger lead
Note:
Do not run the machine with the battery
disconnected, electrical damage may occur.
Installing the Battery
1. Position the battery in the tray with the terminal
posts toward the operating position (Figure 36).
2. Install the positive (red) battery cable to the positive
(+) battery terminal using the fasteners removed
previously.
3. Install the negative battery cable to the negative
(-) battery terminal using the fasteners removed
previously.
4. Slide the red terminal boot onto the positive (red)
battery post.
5. Secure the battery with the hold-down (Figure 36).
6. Lower the seat.
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse:
•
Main F1-30 amp, blade-type
•
Charge Circuit F2-25 amp, blade-type
1. Remove the four screws securing the control panel
to the machine. Retain all fasteners
2. Lift the control pane up to access the main wiring
harness and fuse block (Figure 38).
3. To replace a fuse, pull out on the fuse to remove it
(Figure 38).
30
25
30
25
G014540
2
1
Figure 38
1.
Main-30 amp
2.
Charge circuit-25 amp
4. Return the control panel to its original position. Use
the four screws removed previously to secure the
panel to the machine.
32
Summary of Contents for SS 3200
Page 46: ...Schematics G014644 Electrical Diagram Rev A 46 ...
Page 47: ...Notes 47 ...
