Lubrication
Greasing the Bearings
Service Interval:
Every 25 hours—Grease all
lubrication points.
Grease Type:
No. 2 General Purpose Lithium Base
Grease
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
park position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings (Figure 25 and Figure 26)
with a rag. Make sure to scrape any paint off of the
front of the fitting(s).
1
G014522
Figure 25
1.
Front caster tire
Figure 26
Located on the seat pan underside
1.
Read the instructions
before servicing or
performing maintenance.
3.
Grease every 25 operating
hours.
2.
Check tire pressure every
25 operating hours.
4.
Engine
4. Connect a grease gun to each fitting (Figure 25 and
Figure 26). Pump grease into the fittings until grease
begins to ooze out of the bearings.
5. Wipe up any excess grease.
25
Summary of Contents for SS 3200
Page 46: ...Schematics G014644 Electrical Diagram Rev A 46 ...
Page 47: ...Notes 47 ...
