Toro REELMASTER 6700 D, Operator'S Manual

Page: 19 / 56

If the light blinks during operation, it may indicate any
of the following:
•
The machine is being operated faster than the
maximum speed value initially programmed into
the ECU.
•
An electrical malfunction has been detected (open
or shorted output.
•
A hydraulic leak has been detected (Only if
Turfdefender leak detector is installed on machine)
•
A communications error has been detected (Only if
Turfdefender leak detector is installed on machine)
Key Switch
The key switch ( Figure 20 ) has 3 positions: O
FF
,
O
N
/P
REHEAT
, and S
TART
.
Speedometer
The speedometer ( Figure 20 ) indicates the ground
speed at which the machine is traveling.
Brake Pedals
Two brake pedals ( Figure 20 ) operate individual wheel
brakes for turning assistance, parking, and to aid in
obtaining better sidehill traction. Locking pin connects
the pedals for parking brake operation and transport.
Parking Brake Latch
A knob on the left side of the console actuates the
parking brake latch (
Figure 20 ). To engage the parking
brake, connect the pedals with the locking pin, push
down on both pedals, and pull the parking brake latch
out. To release the parking brake, press both pedals
until the parking brake latch retracts.
Reverse Speed Limiter
Adjust the screw ( Figure 20 ) to limit the amount that
you can press the traction pedal in the rearward
direction to limit speed.
Lower Mow/Raise Control Lever
This lever ( Figure 21 ) raises and lowers the cutting
units and also starts and stops the reels when you
enable the reels in the mow mode. You cannot lower
the cutting units when the mow/transport lever is in
the transport position.
Fuel Gauge
The fuel gauge ( Figure 21 ) indicates the level of fuel
in the tank.
Engine Oil Pressure Warning Light
This light ( Figure 21 ) indicates dangerously low
engine oil pressure.
g019448
Figure 21
1. Throttle control 7. Glow plug indicator light
2. Lower mow/raise control
lever 8. Engine coolant
temperature gauge
3. Fuel gauge 9. Enable/disable switch (#7)
right rear
4. Charge indicator 10. Enable/disable switch
(Master)
5. Engine oil pressure
warning light 11. Enable/disable switch (#6)
left rear
6. Engine coolant
temperature warning
light
Throttle Control
Move the control ( Figure 21 ) forward to increase
engine speed, rearward to decrease speed.
Engine Coolant Temperature
Warning Light
The light ( Figure 21 ) illuminates and the engine shuts
down when the coolant reaches a dangerously high
temperature.
Glow Plug Indicator Light
When the indicator light ( Figure 21 ) is lit, it indicates
that the glow plugs are on.
Enable/Disable Switch
Use the enable/disable switch in conjunction with the
lower mow/raise control lever to operate the cutting
units (
Figure 21 ).
19