1.
Remove the locknut and the washer securing the pivot
rod to the number 2 lift arm (
). Remove the
pivot rod and spring from the lift arm. Repeat the
procedure on the number 1 and number 3 lift arms.
Figure 3
1.
Pivot rod
2.
Tipper support bracket
w/roller
Note:
The tipper bracket with the roller and the tipper
support brackets are not required when operating the
DPA cutting units (
2.
Disconnect the lift chains from the cutting units, if
attached.
3
Mounting the Lift Brackets and
Chains
Parts needed for this procedure:
5/7
Lift chain
5/7
Chain bracket
5/7
U-bolt
10/14
Nut
5/7
Screw
5/7
Washer
5/7
Nut
Procedure
Mount a chain bracket to each lift arm with a U-bolt and 2
nuts. Position the brackets as follows:
Note:
Refer to
to determine the lift arm number
being described.
Figure 4
1.
Cutting unit 1
6.
Cutting unit 6
2.
Cutting unit 2
7.
Cutting unit 7
3.
Cutting unit 3
8.
Reel motor
4.
Cutting unit 4
9.
Weight
5.
Cutting unit 5
1.
On lift arm numbers 1, 4, and 5, position the chain
brackets and U-bolts 38.1 cm (15 inches) behind the
center line of the pivot knuckle (
).
2.
On lift arm numbers 1 and 5 the brackets should be
rotated to the right 10 degrees from vertical (
).
3.
On lift arm number 4 the bracket should be rotated to
the left 10 degrees from vertical (
1
2
3
g020546
Figure 5
1.
Lift arm number 5 =
38.1 cm (15 inches)
3.
Lift arm numbers 1 and 5 =
10 degrees
2.
Lift arm number 4 =
10 degrees
4.
On lift arm numbers 2 and 3, position the brackets and
U-bolts 38.1 cm (15 inches) behind the center line of
the pivot knuckle (
).
Note:
Rotate the brackets 45 degrees to the outboard
side of the machine.
5
