Toro Reelmaster 5610, Operator'S Manual

Page: 36 / 68

g031851
Figure 55
1. Front tie-down
•
Rear—each side of the machine on the rear frame
(
Figure 56 )
g004555
Figure 56
1. Rear tie-down
Pushing or Towing the
Machine
In an emergency, the machine can be moved
by actuating the bypass valve in the variable
displacement hydraulic pump and pushing or towing
the machine.
Important:
Do not push or tow the machine faster
than 3 to 4.8 km/h (2 to 3 mph) because internal
transmission damage may occur. The bypass
valve must be open whenever you push or tow
the machine.
1. The bypass valve is located on the left side of
the hydrostat (
Figure 57 ). Rotate the bolt 1-1/2
turns to open and allow fluid to bypass internally.
Note:
You can now move the machine slowly
without damaging the transmission.
g003995
Figure 57
1. Bypass valve
2. Close the bypass valve before starting the
engine. However, do not exceed 7 to 11 N∙m. (5
to 8 ft-lb) torque to close the valve.
Important:
Running the engine with the
bypass valve open causes the transmission
to overheat.
36