Toro Reelmaster 5510 Series, Service Manual, Page: 631 / 662

Idler Assembly
g220503
Figure 396
1. Socket-head screw (2 each) 6. Threaded insert (right) 11. Clevis pin
2. Pivot hub 7. Shield 12. Cotter pin
3. O-ring 8. Stub shaft 13. Bearing
4. Idler arm 9. Flocked bearing shield
(2 each) 14. Retaining ring
5. Threaded insert (left) 10. Collar 15. Flange nut
Note: The groomer idler assembly is located on the same side of the cutting
unit as the cutting unit hydraulic motor.
Removing the Idler Assembly
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, shut off the engine, set the parking brake, and
remove the key from the key switch.
2. Remove the hydraulic reel motor from the cutting unit; refer to Removing the
Hydraulic Reel Motor (page 9–17) .
3. Remove the groomer reel assembly; refer to Removing the Groomer Reel
(page 11–13) .
4. Remove the cotter pin and clevis pin from the height adjustment rod at the
front of the idler arm. Discard the cotter pin.
5. Remove the 2 socket-head screws (item 1 in Figure 396 ) that secure the
pivot hub to the cutting unit, and remove the pivot hub and idler assembly
from the cutting unit.
6. Inspect the shields, bearing, and bushing in the idler assembly. Remove and
discard the components that are worn or damaged.
Reelmaster ® 5410/5510/5610 Series Page 11–11 Universal Groomer (Optional): Service and Repairs
15216SL Rev C