Toro Reelmaster 5510 Series, Service Manual

Page: 46 / 662

Removing the Exhaust System (continued)
1. Park machine on a level surface, lower cutting units, stop engine, engage
parking brake and remove key from the key switch. Raise and support hood.
2. Raise and support hood to gain access to exhaust system. Allow engine and
exhaust system to cool before doing any disassembly of exhaust system
components.
g229075
Figure 15
Reelmaster 5610
1. Exhaust header
5. Muffler
9. Tailpipe bracket
2. Flange nut (4 each) 6. Carriage screw (4 each) 10. Tailpipe bracket
3. Exhaust gasket 7. Flange nut (4 each) 11. Flange nut (2 each)
4. Clamp assembly (2 each) 8. Support bracket 12. Flange-head screw (2
each)
3. Remove exhaust system components from the engine as necessary ( Figure
14 or Figure 15 ). Discard exhaust gasket if it is removed.
Installing the Exhaust System
Note: Ensure that all exhaust system flanges and sealing surfaces are free of
debris or damage that may prevent a tight seal.
1. Ensure to install new exhaust gasket if old gasket was removed. Do not use
any type of gasket sealant on gasket or flange surfaces.
2. Assemble all removed exhaust system components ( Figure 14 or Figure 15 ).
A. On Reelmaster 5410 and 5510 machines, shorter leg of rubber hanger
(item 15 in Figure 14 ) should be attached to tailpipe.
B. Ensure that the exhaust support brackets are secure to the engine before
attaching any other exhaust system components.
C. During exhaust system installation, loosely assemble all exhaust system
components before fully tightening any of the fasteners. When tightening
Kubota Diesel Engine: Service and Repairs Page 3–12 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C