Toro Reelmaster 5510 Series, Service Manual

Page: 382 / 662

Troubleshooting
CAUTION
Remove all the jewelry, especially rings and watches, before doing
any electrical troubleshooting or testing. Disconnect the battery
cables unless the test requires battery voltage.
For the effective troubleshooting and repairs, you must have a good
understanding of the electrical circuits and components that are used on this
machine; refer to the Electrical Schematic and Wire Harness Drawings/Diagrams
in
Appendix A (page A–1) .
If the machine has any interlock switches that are bypassed, connect the
switches for the correct troubleshooting and safety.
Note: Use the InfoCenter display when troubleshooting a Reelmaster electrical
problem.
Operator Advisories
If controls are not selected properly to allow certain machine operations, the
InfoCenter indicator light will illuminate and an advisory will be displayed on the
InfoCenter display, refer to
Operator Advisory Screen (page 7–13) .
Advisory numbers, descriptions, and reason for advisories are listed in the
Advisories Table (page 7–26) . Some advisories can be caused by several
machine settings.
Advisories Table
Advisory
Number
Advisory Description Possible Reason for Advisory
160 Inhibit start Neither seat occupied nor parking brake
applied
Traction pedal is not in N
EUTRAL
position
Wait to start until system functions have been
initialized
Joystick is in R
AISE
position
Joystick is in L
OWER
position
161 Inhibit PTO No operator in seat
Engine coolant temperature is excessive
162 Inhibit cutting unit lower Mow speed limiter is in T
RANSPORT
position
169 Engine shutdown No operator in seat
Parking brake is applied
Engine coolant temperature is excessive
Engine oil pressure is low
170 Recycle key switch Engine starter motor has been engaged for
30 seconds
Electrical System: Troubleshooting Page 7–26 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C