2.
Secure the lift bracket to #1 lift chain (rear
center) with a long shackle, clevis pin, and cotter
pin (
).
Note:
Ensure that there are no kinks or twists
in the chain before installing the cutting units.
g012762
Figure 13
1.
Lift bracket
5.
Capscrew and locknut
2.
#1 lift chain
6.
Spring
3.
Long shackle
7.
S-hook
4.
Clevis pin and cotter pin
8.
Lift bail
3.
Using the bottom mounting hole in the lift
bracket, secure the lift bracket to the mower
mounting bracket with a capscrew (3/8 x 1-1/2
inch) and locknut (3/8 inch) as shown in
4.
Hook the spring to the upper mounting hole in
the lift bracket and the other end of the spring to
the lift bail with the S-hook (
).
5.
On the remaining mowers, secure the lift chains
to the mower mounting bracket with the long
shackles, clevis pins, and cotter pins (
).
Note:
Ensure that there are no kinks or twists
in the chain before installing the cutting units.
g012763
Figure 14
1.
Mounting bracket
5.
Spring
2.
Long shackles
6.
S-hook
3.
Clevis pin and cotter pin
7.
Lift bail
4.
Fifth link from mower
6.
Hook the spring to the fifth link in the chain from
the mower and secure the other end of the
spring to the lift bail with an S-hook (
).
7
Checking the Tire Air
Pressure
No Parts Required
Procedure
1.
Check the tire air pressure daily.
You should measure 165 to 193 kPa (24 to 28
psi).
12
