Toro Proline 30187, Operator'S Manual

Page: 12 / 48

outside. Secure it with a washer and hairpin
cotter pin (Figure 5).
2. Remove the hairpin cotter pin and rod from
the upper control bars.
3. Press and hold upper control bars against the
reference bar, so the stop hits.
4. Push the rod forward until the bearing is
against control bracket stop. Thread the rod in
or out of fitting on control bracket until the
rod aligns with holes in upper control bars
(Figure 5).
5. When the rod and holes in the upper control
bars line up, turn the rod one additional turn,
so the rod is shorter.
Note:
The upper control bar stop must hit
the reference bar before the roller hits the
control bracket stop (Figure 5).
6. Connect the rod to upper control bars with the
previously removed hairpin cotter (Figure 5).
Figure 5
1. Control rod 4. Clevis pin
2. Control bracket 5. Washer
3. Rod tting 6. Hairpin cotter pin
Step
4
Installing the Right Control
Rod
Parts needed for this step:
1 Right control rod
1 Hairpin cotter pin
1 Clevis pin
1 Rod tting
Procedure
1. Slide the rod into the control bracket and
secure it with a hairpin cotter pin (Figure 6).
2. Remove the hairpin cotter pin and rod from
the upper control bars.
3. Press and hold upper control bars against the
reference bar, so the stop hits.
4. Push the rod forward until the bearing is
against the control bracket stop. Thread the
rod in or out of fitting on control bracket until
the rod aligns with holes in upper control bars
(Figure 6).
5. When the rod and holes in the upper control
bars line up, rotate the turnbuckle one
additional turn, so the rod is shorter.
Note:
The upper control bar stop must hit
the reference bar before the roller hits the
control bracket stop (Figure 6).
6. Connect the rod to upper control bars with the
previously removed hairpin cotter, tighten the
wing nut and turnbuckle (Figure 6).
12