Toro ProLine 30180, Operator'S Manual

Page: 15 / 44

Set-Up
13
Mount Control Panel and Fuel
Tank
1. Position control panel under bottom of rear
frame (Fig. 1). Align fuel tank to top of rear
frame (Fig. 1).
1716
1
2
3
Figure 1
1. Rear frame
2. Control panel
3. Fuel tank
2. Secure control panel and fuel tank to rear frame
with (4) 7/8 in. (22.5 mm) bolts, lock washers
and washers (Fig. 2).
3. Slide hose clamp onto fuel line (Fig. 2). Push
fuel line onto fuel tank fitting and secure with
hose clamp (Fig. 2).
1717
1
2
3
5
4
6
Figure 2
1. Bolt 5/8–18 x 7/8”
(22.5 mm)
2. Lock washer
3. Washer
4. Fuel line
5. Hose clamp
6. Fuel fitting
Install Shift Lever
1. Align mounting block with flats of shaft on top
of transmission and slide onto shaft (Fig. 3).
Note: DO NOT remove rubber washer on
transmission shaft.
2. Slide shift lever through control panel and align
mounting hole in lever with mounting block on
transmission. Secure lever to transmission with
51 mm bolt and washer. Torque bolt to
115 in. lb. (155 N.m).
1
2
1718
4
3
Figure 3
1. Mounting block
2. Shift lever
3. Bolt 1/4–28 x 2” (51 mm)
4. Washer