Toro ProLine 14 HP, Operator'S Manual, Page: 17 / 52

Assembly
15
Connect Wire Harness
4. Route wire harness inside of frame, along left
handle and over throttle cable. Compress wire
harness covering and press into lower and upper
holes in rear of control panel (Fig. 3).
5. Thread harness up through rear tube of traction
handle (Fig. 3).
m–3774
Figure 3
1. Wire harness
2. Control panel
3. Tube
4. Wire tie
6. Insert terminals into plastic plug until the clips
snap into position (Fig. 3). If they do not snap
turn around and try again.
7. Push plug onto switch so latches interlock
(Fig. 3).
8. Secure wire harness and throttle cable to left
handle, away from PTO lever, with wire tie
(Fig. 3).
m–3782
Figure 4
1. Terminal
2. Clip
3. Plastic plug
4. Switch
Install Traction Control Rods
1. Thread trunnions equal distance onto each
control rod. For a starting point thread on
approximately 2 in. (51 mm) (Fig. 5).
2. With trunnion rod up, slide clevis pins through
rod fittings and mounting holes in idler brackets
(from outside) (Fig. 5). Secure with 1/4” (6 mm)
washers and hairpin cotters (Fig. 5).
m–3785
Figure 5
1. Control rod
2. Trunnion
3. Idler bracket
4. Clevis pin
5. Washer 1/4” (6 mm)
6. Hairpin cotter