2
Mounting the Hitch to the
Debris Blower
Parts needed for this procedure:
1
Debris blower assembly
1
Hitch
2
Bolt (3/8 x 3 inches)
2
Flange nut (3/8 inch)
Procedure
1.
Position the debris blower on a flat, level surface.
2.
Insert the hitch tube into the frame brackets (Figure
6). Secure the tube to the frame with 2 bolts (3/8 x 3
inches) and flange nuts (3/8 inch).
G020731
1
2
Figure 6
1.
Frame brackets
2.
Hitch tube
3.
Route the wire harness along the right side of the hitch
tube (Figure 7).
G020732
1
2
Figure 7
1.
Wire harness
2.
Harness clips
4.
Plug the harness clips into the holes in the side of the
hitch tube to secure it (Figure 7).
5.
Store the harness connector in the hitch tube holster
(Figure 8).
3
Connecting the Debris Blower
to the Tow Vehicle
No Parts Required
Procedure
This trailer uses a coupler that requires a 2 inch ball for the
hitch.
1.
Raise the trailer to a suitable hitch.
2.
Lift the coupler lever on the tongue while lowering the
cover over the ball hitch (Figure 8).
10
Summary of Contents for ProForce 44539
Page 30: ...Notes 30...
Page 31: ...Notes 31...
