Toro Pro Sweep 07068, Operator'S Manual

Page: 18 / 40

Product Overview
Controls
Hopper Dump Button
To dump the hopper, press the hopper dump button
2 times (
Figure 18 ).
Important:
The machine must be directly behind
the towing vehicle and in transport height before
you can activate the dump sequence.
g030468
Figure 18
1. LED light 5. Stop
2. Offset left 6. Sweeper up
3. Sweeper down 7. Offset right
4. Hopper dump
Sweeper Down Button
To lower the hopper, press the sweeper down button
(
Figure 18 ). You can lower the hopper when it is at
any of the following positions:
•
Hopper dump height
•
Transport height
•
Turn around height
Note:
When lowering the hopper from the dump
position, you can stop the lower hopper function at
any time by releasing the sweeper down button.
Note:
With the machine in the transport or
turn-around positions, you can stop the lower
hopper function by pressing the sweeper up
button.
Sweeper Up Button—Standard
Mode
To raise the machine in standard mode, press
the sweeper-up button. The hopper stops at the
pre-defined height (
Figure 18 ).
•
Transport height (home position) is 13-1/4 to
15-1/4 inches.
•
Turn around height (offset position) is 8-1/2 to
10-1/2 inches.
Sweeper Up Button—Optional
Mode
This mode allows you to adjust the machine to any
desired height and it stops at the pre-defined heights.
Note:
Refer to Switching the Sweeper-Up Mode
(page 27) to switch to the optional mode.
To raise the machine in optional mode, press and
hold the sweeper-up button until the hopper reaches
the desired height or stops at the pre-defined height
(
Figure 18 ).
•
Transport height (home position) is 13-1/4 to
15-1/4 inches.
•
Turn around height (offset position) is 8-1/2 to
10-1/2 inches.
Offset Left Button
To offset the machine to the left, press and hold the
offset left button (
Figure 18 ). Releasing the button
stops the movement to the left.
Offset Right Button
To offset the machine to the right, press and hold the
offset right button (
Figure 18 ). Releasing the button
stops the movement to the right.
Stop Button
Pressing the stop button disables any active function.
Note:
There is approximately a 3-second delay.
18