Toro Pro Force 44554, Operator'S Manual

Page: 22 / 36

Note:
To reduce the amount of dust dislodged,
avoid knocking the filter against the air-filter
housing.
5. Inspect the air-filter element.
•
If the air-filter element is clean, install the
filter element, refer to
Installing the Air Filter
(page 22) .
•
If the air-filter element is damaged, replace
the filter element; refer to
Replacing the Air
Filter (page 22) .
Replacing the Air Filter
1. Remove the air-filter element; refer to Servicing
the Air Cleaner (page 21) .
2. Inspect the new filter for shipping damage.
Note:
Check the sealing end of the filter.
Important:
Do not install a damaged filter.
3. Install the new air filter; refer to Installing the Air
Filter (page 22) .
Installing the Air Filter
Important:
To prevent engine damage, always
operate the engine with the complete air-cleaner
assembly installed.
Important:
Do not use a damaged element.
Note:
Cleaning of the used air-filter element is not
recommended due to the possibility of damage to the
filter media.
1. Clean the dirt ejection port located on the
air-filter cover.
2. Remove the rubber outlet valve from the cover,
clean the cavity, and replace the outlet valve.
3. Insert the air-filter element into air-filter housing
(
Figure 13 ).
Note:
Ensure that the filter is sealed properly
by applying pressure to the outer rim of the filter
when installing it. Do not press on the flexible
center of the filter.
4. Align the air-cleaner cover with the air-cleaner
housing (
Figure 13 ).
5. Secure the cover to the housing with the latches
(
Figure 13 ).
Servicing the Carbon
Canister
Replacing the Carbon-Canister Air
Filter
Service Interval: Every 200 hours
1. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
2. Remove and discard the carbon canister air
filter (
Figure 14 ).
g029820
Figure 14
1. Carbon canister 2. Carbon-canister air filter
3. Install the new air filter.
Replacing the Carbon-Canister
Purge-Line Filter
Service Interval: Every 200 hours
Note:
Check the purge-line filter occasionally for dirt.
If the filter appears to be dirty, replace it.
1. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
2. Move the spring-type hose clamps on both sides
of the carbon canister purge-line filter away from
the filter (
Figure 15 ).
22