Toro Power Max 828LXE 38631, Operator'S Manual, Page: 9 / 24

Figure 14
1. Short rod 2. Long chute control rod
4. Insert the front end of the rod into the opening in the
back of the chute gear cover until it slides into the chute
gear (Figure 15).
Figure 15
5. Align the holes in the nested ends of the rods and insert
2 carriage bolts (in the loose parts bag) through the
short rod from the left side of the snowthrower (from
the operating position).
6. Insert the cable clip that supports the deflector cable
onto the forward carriage bolt, and secure the carriage
bolts with locknuts from the loose parts bag (Figure 16).
Figure 16
1. Cable clip 2. Deector cable
7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and deflector
operate smoothly.
5. Connecting the Wire to the
Headlight
1. Insert the wire connector on the loose end of the wire
straight into the back of the headlight until it is securely
in place (Figure 17).
Figure 17
1. Plastic clip on wire
connector
3. Cable tie
2. U-bolt
Note:
Ensure that the plastic clip on the wire
connector is on the bottom (Figure 17).
2. Secure a cable tie (from the loose parts bag) around the
wire and the handle about an inch (2.5 cm) below the
U-bolt (Figure 17).
6. Filling the Engine with Oil
Your snowthrower comes with 26 oz. of oil in the engine.
Note:
Before starting the engine, check the oil level and
add oil if necessary.
Max. fill: 26 oz. (0.77 l), type: automotive detergent oil with
an API service classification of SF, SG, SH, SJ, SL, or higher.
•
For temperatures above 32°F (0°C), use SAE 30W.
•
For temperatures between 0°F and 32°F (-18°C to 0°C),
use SAE 5W30 or SAE 10W.
•
For air temperatures below 0°F (-18°C), use SAE 0W30.
1. Remove the dipstick and slowly pour oil into the oil
fill tube to raise the oil level to the Full mark on the
dipstick.
Do not overfill. (Figure 18).
9