Form No. 3361-375 Rev A
Drive Shield Kit
Power Max
®
Snowthrowers
Model No. 115-5699
Installation Instructions
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Drive shield
1
2
Bolt
2
Install the drive shield.
3
Trim seal
1
Install the trim seal.
1
Removing the Belt Covers and
Cleaning the Snowthrower
Frame
No Parts Required
Procedure
1. Remove the 4 bolts that hold the belt covers in place,
and remove the belt covers.
Note:
Save the screws to install the belt cover.
2. Clean and dry the top of the snowthrower frame to
remove all oil and dirt.
Important:
The sealant will not adhere to a
dirty frame, and an improper seal may allow
moisture to penetrate the seal and leak onto the
friction wheel.
2
Installing the Drive Shield
Parts needed for this procedure:
1
Drive shield
2
Bolt
Procedure
Important:
You will need a flexible silicone RTV
sealant (such as Loctite 5045 or Loctite 5905) to
complete this procedure. The sealant should be
water and oil resistant.
1. Apply 2 parallel beads of sealant to the bottom of
the drive shield (Figure 1).
Note:
Do not apply sealant in the area between the
locating tabs and the front edge of the drive shield
(Figure 1).
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Summary of Contents for Power Max 115-5699
Page 4: ...Notes 4 ...
Page 8: ......
