Toro Multi Pro WM, Operator'S Manual

Page: 18 / 96

Kit for Automatic Workman Utility Vehicles; refer to
the Installation Instructions for the Multi Pro WM Turf
Sprayer Finishing Kit, Automatic Workman Utility
Vehicle.
3
Installing the Hold-Down
Brackets for the Tank Skid
Parts needed for this procedure:
2 Hold-down brackets
Procedure
1. Remove the 2 rear flange-head bolts and 2
flange locknuts that secure the support bracket
for the engine tube to the frame of the machine
(
Figure 6 ).
Note:
Retain the fasteners for later use.
g028410
Figure 6
1. Rear hole—support
bracket (engine tube) 4. Engine support tube
2. Flange locknut
5. Lift cylinder
3. Flange-head bolt
2. Rotate the lift cylinder to provide clearance to
install the hold-down bracket for the tank skid
(
Figure 6 ).
3. Assemble the hold-down brackets to support
bracket and frame the using the 2 flange-head
bolts and flange locknuts removed in step
1
( Figure 7 ).
g028421
Figure 7
1. Support bracket (engine
tube) 3. Flanged-head bolts
2. Hold-down bracket (tank
skid) 4. Lift cylinder
4. Torque the bolts and nuts to 91 to 113 N∙m (67
to 83 ft-lb).
5. Repeat steps 1 to 4 at the opposite side of the
machine.
18