Form No. 3439-987 Rev A
Multi Pro
®
5800 Turf Sprayer with ExcelaRate
®
Spray System
Model No. 41393—Serial No. 400000000 and Up
Model No. 41394—Serial No. 402700001 and Up
Model No. 41394CA—Serial No. 400000000 and Up
Software Guide
Read this information carefully to learn how to operate and maintain your product properly and to avoid injury
and product damage. You are responsible for operating the product properly and safely.
Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service Dealer
or Toro Customer Service and have the model and serial numbers of your product ready.
You may contact Toro directly at
www.Toro.com
for product safety and operation training materials, accessory
information, help finding a dealer, or to register your product.
Introduction
The Software Guide for the Multi Pro 5800-D and
5800-G Turf Sprayer with ExcelaRate Spray System
provides information for using sprayer system
information and control sprayer system functions.
Contents
Before You Begin Spraying ................................. 1
Product Overview ..................................................... 2
Controls ............................................................. 2
Operation .................................................................. 3
Before Operation ................................................... 3
Accessing the Main Menu Screen ....................... 3
InfoCenter Main Sub Menus ............................... 4
Calibrating the Sprayer ..................................... 14
During Operation ................................................. 26
InfoCenter Spray Area Screens ........................ 26
InfoCenter Advisories ....................................... 28
InfoCenter Fault Codes..................................... 29
Maintenance ........................................................... 30
Service Screens ............................................... 30
Diagnostics Screens......................................... 31
About Screens .................................................. 32
Setup
Before You Begin Spraying
Preparing the Machine when
Spraying in the Application Rate
Mode
1.
Fill the sprayer tank and fresh water tank; refer
to filling the spray tank and filling the fresh-water
tank procedures in the
Operator’s Manual
.
2.
Calibrate the sprayer system; refer to
the Sprayer (page 14)
.
3.
Set the application rate value(s) and active
application rate for the sprayer job; refer to
Setting the Rate 1 or Rate 2 Value (page 5)
and
Setting the Active Rate (page 4)
.
4.
As needed, configure the following optional
settings:
•
Set the boost percentage; refer to
Boost Percentage (page 5)
.
•
If you are using the
LOW LIMIT INDICATOR
,
enter the volume of chemical in the sprayer
tank; refer to
Setting the Tank Volume (page
6)
.
•
Set the low limit indicator and the low limit
volume value for the tank; refer to
Low Limit Indicator (page 6)
and
Low Limit Volume Value (page 7)
.
•
Set the preset agitation value; refer to
the Preset Agitation Value (Application Rate
Mode Only) (page 7)
.
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3439-987* A
