10
SETTING UP WATERING PROGRAMS
SETTING STATION RUN TIMES
SUSPENDING AUTOMATIC WATERING
CLEARING ALL PROGRAMS
The Station Run Time is the length of time the Station will water during the programmed watering cycle.
Run times can be set from 0 (off) to 12 hours, 59 minutes, in one-minute increments.
A Station is assigned to a Program when it is given a run time. If the run time for a Station is set to zero
(0:00) in a program, that Station will not be watered in that Program.
To stop all automatic watering cycles, turn the
Control Dial
to
OFF
. The display will show
ALL
OFF
.
All programmed information will be retained and
the clock will continue to run.
To resume the programmed watering schedules,
turn the
Control Dial
to
AUTO RUN
. Irrigation will
begin from the next scheduled start time.
All programmed information can be cleared.
1
Select
AUTO RUN
on the
Control Dial
.
2
Press and hold the , , and buttons simultaneously for 5 seconds.
This removes all programming but does not reset the clock and calendar.
In the example below, Program 1 has been set to
water Station 2 for 30 minutes.
1
Select
SET STATION RUN TIMES
on the
Control Dial
.
This will cause the
Station No
to flash.
2
Use the button to select the
Program
required.
3
Use the and buttons to select the
Station
number.
4
Press and
HOUR
will flash. Use the and
buttons to set the number of hours of
wateringrequired on that Station. Typically,
this will be 0, but could be up to 12.
5
Press and
MIN
will flash. Use the and buttons to set the number of minutes of watering
required on that Station.
6
Repeat steps 2 to 5 until all
Station Run Times
have been programmed for all
Programs
.
HOUR
0: 30
STATION
No
MIN
RUN TIME
2
PROG
No
1