Toro HoverPro 400, Operator'S Manual, Page: 8 / 20

g017530
g017530
Figure 5
1. The oil level is at its
maximum. 3. The oil level is too
low—add oil to the
crankcase.
2. The oil level is too
high—remove oil from
the crankcase.
3. Slowly pour oil into the oil-fill hole, wait 3
minutes, and check the oil level on the dipstick
by wiping the dipstick clean and then inserting,
but not screwing in, the oil-fill cap into the hole
( Figure 6 ).
g017532
g017532
Figure 6
Note:
Fill the engine crankcase with oil until
the dipstick indicates that the engine oil level
is correct as shown in
Figure 5 . If you overfill
the engine with oil, remove the excess oil as
directed in
Changing the Engine Oil (page 15) .
4. Install the dipstick and hand tighten it securely.
Important:
Change the engine oil after the
first 5 operating hours ; change it yearly
thereafter. Refer to Changing the Engine Oil
(page 15) .
Product Overview
g017382
Figure 7
1. Handle 4. Handlebar securing knob
2. Operator-presence control 5. Footstop
3. Switch box
g017377
1
2
3
4
5
6
7
8
9
10
11
g017377
Figure 8
1. Spark plug 7. Fuel-cap-vent knob
2. Exhaust guard 8. Fuel cap
3. Exhaust 9. Choke lever
4. Dipstick 10. Air cleaner
5. Finger guard 11. Carburetor
6. Starter grip
8