Toro Groundsmaster 3320 Series, Installation Instructions Manual

Page: 11 / 20

7. Secure the hose assembly to the bracket with a retaining
ring.
8. Connect the appropriate hydraulic hose from the
hopper assembly to the hoses installed to the coupler
bracket.
Figure 17
1. Top hydraulic hose 4. Dust cap
2. Coupler bracket
5. Bottom hydraulic hose
3. Retaining ring 6. Dust plug
4
Installing the Hopper-Stop
Assembly
Parts needed for this procedure:
1 Hopper-stop assembly
2 Bolt (1/2 x 4-1/2 inch)
2 Locknut (1/2 inch)
Procedure
1. Remove the 2 bolts and nuts securing the ROPS tube
to the right side of the machine (
Figure 18 ).
1
G024265
2
3
4
Figure 18
1. ROPS tube 3. Locknuts (1/2 inch)
2. Hopper-stop assembly 4. Bolts (1/2 x 4-1/2 inch)
2. Mount the hopper stop assembly to the outside of
the ROPS tube with 2 bolts (1/2 x 4-1/2 inch) and
locknuts (1/2 inch) as shown in
Figure 18 .
Note:
Ensure that you position the hopper stop with
the pad surface forward of the ROPS tube.
5
Connecting the Wire Harness
Parts needed for this procedure:
1 Wire harness
6 Cable ties
Procedure
1. Unplug the wire harness connector from the seat
switch.
2. Plug the tee end of the hopper-switch harness into the
seat switch and the seat-switch harness.
3. Route the harness to the hopper switch mounted to
the frame tube (
Figure 19 ) and plug the harness into
the switch.
11