Toro Groundsmaster 3300 Series, Operator'S Manual

Page: 34 / 68

Canceling a Parked or Recovery Regeneration
Use the P
ARKED
R
EGEN
C
ANCEL
or R
ECOVERY
R
EGEN
C
ANCEL
setting to cancel a running parked or recovery
regeneration process.
1. Access the DPF Regeneration menu, scroll
down to the P
ARKED
R
EGEN
option or the
R
ECOVERY
R
EGEN
option.
2. Press the next screen to cancel a Parked Regen
or cancel a Recovery Regen.
Starting the Engine
1. Sit on the operator’s seat and fasten the seat
belt.
2. Ensure that the parking brake is engaged and
the PTO is disengaged.
3. Preheat the engine by rotating the key switch to
the O
N
/P
REHEAT
position.
Note:
An automatic timer controls the preheat
for 6 seconds.
4. Rotate the key to the S
TART
position, crank the
engine for no longer than 15 seconds, and allow
the key to return to the O
N
/P
REHEAT
position.
Note:
If additional preheating is required,
turn the key to the O
FF
position, then to the
O
N
/P
REHEAT
position. Repeat this process as
needed.
5. Move the throttle to idle speed or partial throttle
and run the engine until it warms up.
Resetting the PTO Function
Note:
If you leave the operator’s seat while the
PTO switch is in the O
N
position, the machine will
automatically shut off the engine.
Perform the following to reset the PTO function:
1. Push down the PTO switch.
2. Start the engine; refer to Starting the Engine
(page 34) .
3. Pull up the PTO switch.
Shutting Off the Engine
1. Use the throttle control to lower the engine
speed.
2. Move the PTO switch to the O
FF
position.
3. Rotate the key switch to the O
FF
position and
remove the key from the switch.
After Operation
After Operation Safety
General Safety
•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator’s position, Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
If the cutting units are in the transport position, use
the positive mechanical lock (if available) before
you leave the machine unattended.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Remove the key and shut off the fuel (if equipped)
before storing or hauling the machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Maintain and clean the seat belt(s) as necessary
Servicing the Cutting Unit
You can rotate the cutting unit from the T
RANSPORT
position (A in Figure 30 ) to the S
ERVICE
position (B in
Figure 30 ). Use the S
ERVICE
position to maintain the
cutting unit blades or clean underneath the cutting
unit; refer to your cutting unit
Operator’s Manual .
34