Toro Groundsmaster 139-1030, Installation Instructions Manual

Page: 6 / 12

6
Removing the I-Terminal
Wire from the Alternator
Parts needed for this procedure:
1 Wire cap
1 Wire label
1 Vinyl cap
1 Nut (M5)
1 Cable tie
Procedure
1. Locate and remove the I-terminal wire (green
wire) on the alternator (
Figure 12 ).
g283948
Figure 12
1. Nut 4. Alternator post—Remote
sense terminal
2. Ring terminal (I-terminal
wire) 5. Alternator post—I terminal
3. I-terminal wire (green wire) 6. Alternator post—R
terminal
2. Cut off and discard the ring terminal from the
wire (
Figure 12 ).
3. Install the wire cap on the end of the cut green
wire and crimp (
Figure 13 ).
g284893
Figure 13
1. Vinyl cap 4. Alternator post—I terminal
2. Wire cap 5. Nut (M5)
3. Wire label
4. Install the wire label onto the wire ( Figure 13 ).
5. Use a cable tie to secure the wire to the wire
harness.
6. Install a nut (M5) flush with the top of the
alternator post (
Figure 13 ).
7. Install a vinyl cap over the alternator post ( Figure
13 ).
Note:
The nut (M5) helps to secure the vinyl
cap over the post.
6