Removing and Installing the Traction Control Components (continued)
g314863
Figure 116
1.
Pedal end
2.
Pump end
B. Attach the ball joints to the pump lever and the traction pedal hub.
C. Fit the cable housing into the support bracket with a flat washer and a
jam nut on each side of the bracket. Center the cable housing threads on
the bracket and tighten the jam nuts.
D. Clamp the traction cable to the cable bracket below the operator’s
platform.
E. Check the traction pedal operation and adjust the traction cable before
returning the machine to service; refer to
(page 7–3)
.
3. After assembly, make sure that the traction (piston) pump is properly adjusted
for the N
EUTRAL
position (the machine must not creep in either direction on
level ground when the traction pedal is in the N
EUTRAL
position); refer to
Adjusting the Traction System for Neutral (page 5–50)
.
Chassis: Service and Repairs
Page 7–12
Groundsmaster
®
3200, 3300 and 3310
19240SL Rev A
Summary of Contents for Groundmaster 31900
