Traction Pedal, Cable, and Control Assembly
g302086
Figure 115
1.
Pad – forward
13.
Jam nut (2 each)
25.
Clamp
2.
Pad – reverse
14.
Lock washer (2 each)
26.
Socket head screw (2 each)
3.
Plastic washer (2 each)
15.
Lock nut
27.
Spacer – 9 mm (0.35 inch)
4.
Pedal hub
16.
Support bracket
28.
Washer (2 each)
5.
Roll pin
17.
Damper
29.
Washer (2 each)
6.
Lock nut (2 each)
18.
Pump lever
30.
Cable bracket
7.
Carriage bolt (12 each)
19.
Pinch bolt
31.
Lock nut (2 each)
8.
Pedal bracket
20.
Cap screw (2 each)
32.
Pedal stop bolt
9.
Bearing (2 each)
21.
Cap screw
33.
Traction pedal
10.
Flange nut (12 each)
22.
Ball joint (2 each)
34.
Roll pin
11.
Cap screw (2 each)
23.
Spacer – 5 mm (0.21 inch)
35.
Forward pedal
12.
Neutral switch
24.
Traction cable
Removing and Installing the Traction Control Components
Remove and install the traction control components as necessary.
1. Apply anti-seize lubricant to the traction pedal shaft during assembly.
2. If the traction cable is being replaced:
A. Install the ball joints on the cable ends at the location shown; refer to
.
Groundsmaster
®
3200, 3300 and 3310
Page 7–11
Chassis: Service and Repairs
19240SL Rev A
Summary of Contents for Groundmaster 31900
