4
Installing the Transport
Wheels
Optional
Parts needed for this procedure:
2
Transport wheels—Transport Wheel Kit (Model No.
04123 [Optional])
Procedure
1.
Use your foot to push the center of the kickstand
down and pull up on the lower handle support
until the kickstand has rotated forward and over
center (
g016833
Figure 9
1.
Kickstand
2.
Press the wheel locking clip toward the center
of wheel and slide the wheel onto the hex shaft
(
).
g017591
Figure 10
1.
Locking clip
3.
Rotate the wheel back and forth until it fits onto
the axle and the locking clip is secured in the
groove on the axle shaft.
4.
Repeat the procedure on the opposite side of
the machine.
5.
Inflate the tires to 83 to 103 kPa (12 to 15 psi).
6.
Carefully lower the machine off of the kickstand
by pushing forward slowly or by lifting the lower
handle support, allowing the kickstand to spring
back to the S
TORAGE
position.
5
Checking the Engine-Oil
Level
No Parts Required
Procedure
Check the engine-oil level; refer to
Engine-Oil Level (page 30)
.
10
