Toro Greensmaster Flex 21, Service Manual

Page: 108 / 150

Greensmaster Flex 21 Page 7 – 24 Cutting Unit (Rev. C)
Cutting Reel
1. Shield frame
2. Adjust nut
3. Bedbar adjuster nut
4. Flange bearing
5. Cap screw
6. Lock washer
7. Detent
8. Spring wave washer
9. Retaining ring
10. Bedbar adjuster screw
11. Washer
12. Compression spring
13. Lock nut
14. LH side plate
15. Flange head screw (2 used per side)
16. Outer oil seal
17. Reel bearing housing
18. Ball bearing
19. RH side plate
20. Plow bolt (2 used per side)
21. Retaining ring
22. Tapered nut (2 used per side)
23. Wave washer
24. Nylon bushing
25. Bushing
26. Reel assembly
27. Pitch arm bushing
28. LH pitch arm
29. RH pitch arm
30. Reel bearing lock nut
31. Spacer
32. Pulley spacer
33. Drive pulley
34. Flange nut
35. Retaining ring (if equipped)
36. Woodruff key
37. Thrust washer (if equipped)
38. Lock nut
39. Counterweight
40. Inner oil seal
Figure 39
16
21
18
23
24
25
22
21
40
15
2
3
4
5
6
7
4 8
9 10
11
12 13
14
15
40
18
17
16
29
27
26
27
20
17
28
Anti–seize lubricant
FRONT
RIGHT
160 to 175 in–lb
(182 to 200 kg–cm)
1
19
31
32
33 34
35
Threadlocking
Compound
36
38
39
30
37
Anti–seize
lubricant
Removal (Fig. 39)
1. Remove cutting unit from machine (see Separating
Cutting Unit from Traction Unit in this chapter). Place
cutting unit on a flat level surface or on a stable work
bench.
NOTE: If a groomer is installed, remove the cutting reel
using the procedures in Cutting Reel in the Service and
Repairs Section of Chapter 8 – Groomer (Model 04201)
or Chapter 9 – Groomer (Model 04204).
2. Remove bedbar from the cutting unit (see Bedbar
Removal in this section).
3. Remove belt cover and reel drive belt from the left
side of the cutting unit (see Reel Drive Belt Replacement
in Chapter 4 – Traction and Reel Drive Systems).
4. Block reel with a piece of wood to prevent reel from
turning. Remove flange nut that secures drive pulley to
the reel shaft. Pull pulley from the shaft. Remove wood-
ruff key and pulley spacer from reel shaft.